Cut some 14 x 34 x 3-inch sticks and flatten the ends. Wrap strips around a dowel and use the dowel to sand curves and profiled moldings.
Remove the doors and drawers.
How to sand and paint wood kitchen cabinets. Sanding the kitchen cabinet doors and frames is hard work but pretty straightforward. Wrap 34-inch strips of sandpaper around the flattened end and use the stick to sand in corners and along edges. For a smoother finish you could try 240-grit sandpaper.
DO SAND THE CABINETS To create a strong bond between the paint and your cabinet youll need to roughen up the slick laminate with the help. Steps for Painting Kitchen Cabinets Without Sanding Follow these steps for painting your cabinets. How to Sand your Kitchen Cabinets.
Instead of sanding Chris and Lexi use mineral spirits and a rough scrubbing pad to clean the cabinets thoroughly before priming them. Sand the furniture using 180-grit sandpaper. Sanding Sponges for Tight Spaces.
If you dont want to sand before you prime use some mineral spirits and a rough sponge to clean and lightly rough up the cabinet area youre painting. Sand lightly to knock down the raised grain. Sand the frames drawers and doors until they are smooth.
This not only cleans the cabinet paint doesnt go on well over grease but the scrubby sponge also roughs up. Refinishing your kitchen cabinets is a quite messy job and the last thing you want is to paint all over your kitchen countertops as you learn how to paint and refinish your kitchen cabinets. This doesnt open up the wood cabinet material as much as sanding but does get you some additional grippy area for the primer to adhere to.
The key here is to sand some of the existing finish off and roughen up the surface so the. You dont have to remove the varnish completely just slightly etch the surface so that primer will stick to it. Painting Unfinished Cabinets.
A good tip is to sand in the direction of the grain. Eventually it increases your work and headache because now you have to scratch paint from the countertops too. I used my Ryobi orbital sander on all the flat surfaces basically anything it could reach and used the sanding blocks for the smaller harder to reach moldings and corners.
After sanding wipe away any dust with a damp cloth. Touch up the bare spots and sand them after the primer is dry.